Having an issue with a 50Mg I cleaned for a friend. I have fished these reels for years and cleaned them myself for 5-6 years, so I've taken them apart plenty. For some reason the spool is getting a lot of sideways movement after reassembly. I put his spool in one of my reels and no movement. Put my spool in his reel and movement. The issue seems to be too much leeway on the palming/side plate side of the reel.
Sounds like the spool retaining clip (2024)isn't clicking in on the spool. Ya gotta make sure you get those spool shaft clip holders (2023) in correctly. flat side next to spool bearing(2023), spool retaining clip(2024), then flat side of clip holder facing out(2023), then bearing retainer clip (32)
On the attached diagram spacer B part 664 is probably missing. Quite possible that it was gone before you even got the reel. It is easy for it to stick to the backside of the bearing when it is pulled out. That is the only part that would allow the spool to move too far in that direction.
Thanks everyone. I think Mike nailed it with 664. Going to confirm tonight.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
2 Cool Fishing Forum
7.4M posts
116K members
Since 2004
A forum community dedicated to anglers in the Texas area. Come join the discussion about fishing guides, bait, safety, gear, tackle, tips, reviews, accessories, classifieds, and more!