Welding cart - done

[goldwingtiny]

I did a little reading the other day, PSI "may" make a little difference but not in thickness, hence my above reply to Matt. Cutting 3/16" ish is slow with this 110 version. Slag knocks off a lot easier than Ox/Ac torch slag.[/QUOTE


Ok. Thanks for the info. B-T-W Good job on the cart.

[hurricane matt]

Returned the Eastwood getting my 45xp. Eastwood is ok but similar feeling to using your buddies rod when yours breaks out on the water. Hard to go back to mediocre stuff after having good quality gear.

[reese]

Originally Posted by goldwingtiny

I did a little reading the other day, PSI "may" make a little difference but not in thickness, hence my above reply to Matt. Cutting 3/16" ish is slow with this 110 version. Slag knocks off a lot easier than Ox/Ac torch slag.[/QUOTE


Ok. Thanks for the info. B-T-W Good job on the cart.

One thing I have yet to really try out is that it seems that grounding is really important on these plasma cutters. I still want to do a test to see if I can get to the 1/4" capacity with a really good clean ground. Others say they are doing it.

[hurricane matt]

Hypertherm 45xp and don't look back. 1/2 like butter and severance 1"

[TwoKewl'er]

Originally Posted by hurricane matt

Hypertherm 45xp and don't look back. 1/2 like butter and severance 1"

Best in the biz.......an if you ever decide to run a burn table an use a computer the high frequency want effect it like lesser mfg....

Carry on

[BullyARed]

Very nice job!