2CoolFishing - View Single Post - Air paint spraying setup
View Single Post
Old 08-22-2018, 08:40 AM   #3
Wado
Registered Users-pm+
 
Join Date: May 15 2011
Location: Palacios Texas
Age: 61
Posts: 1,809
Rep Power: 11388224
Wado has been promoted to PirateWado has been promoted to PirateWado has been promoted to PirateWado has been promoted to PirateWado has been promoted to PirateWado has been promoted to PirateWado has been promoted to PirateWado has been promoted to PirateWado has been promoted to PirateWado has been promoted to PirateWado has been promoted to Pirate
HVLP

This is a true HVLP gun that uses compressed air with a pressure pot. HVLP runs below 40 psi and you can also get a gravity feed cup that attaches to the top of the gun but I do the inside of cabinets and need to get at some weird angles so I use the pot. A three gallon compressor is a little small but the good thing about this type is you don't use air until you pull the trigger so your compressor cycles less. You do need a water separator and no oil in the air so filter it. This setup was around $400.00 but Harbor Freight has some cheapies, that's where I got the pot but threw the gun away. I have a better picture somewhere.
Attached Images
  
Wado is offline   Reply With Quote