Just like a paint job, surface prep before hand is critical in my opinion. Having said that, for the most part, that stuff tends to stick very well and hold for a long time. Use a straight edge as a guide for your long straight cuts, and try to use a very sharp blade and hold a consistent angle to try to minimize cut edge imperfections. Lay down masking tape as a guide for your placement. Buy the roller, and roll the snot out of it. You’ll be fine, good luck!
Sent from my iPhone using Tapatalk
11-30-2018 07:43 AM
I bought some for my boat a few years back. It was suggested to me to purchase a roller and take your time. I did what was suggested and it turned out great!
11-28-2018 12:44 PM
DIY hydro turf
Looking for any feed back has anyone used the hydro turf sheets to cut and place on deck kinda like sea dek.
I got a sheet gonna get a few more and give it a go.