2CoolFishing - Reply to Topic
Home  |  Contact Us  |  Advertise   |   Follow:

Go Back   2CoolFishing > General Interest Forums > DIY (Do it yourself) forum > Air paint spraying setup

Thread: Air paint spraying setup Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the 2CoolFishing forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-07-2018 09:49 AM
sammytx Thanks for all the advice. I looked into upgrading my whole air setup but then decided I'm not going to use it enough to be worth it. So I just used a foam roller and saved my pennies for other projects. Worked out fine, it has the rolled texture but it looks good.

08-22-2018 09:40 AM

This is a true HVLP gun that uses compressed air with a pressure pot. HVLP runs below 40 psi and you can also get a gravity feed cup that attaches to the top of the gun but I do the inside of cabinets and need to get at some weird angles so I use the pot. A three gallon compressor is a little small but the good thing about this type is you don't use air until you pull the trigger so your compressor cycles less. You do need a water separator and no oil in the air so filter it. This setup was around $400.00 but Harbor Freight has some cheapies, that's where I got the pot but threw the gun away. I have a better picture somewhere.
08-20-2018 02:38 PM
GT11 I switched to airless years ago so my recollection of air sprayers is a little foggy. First, you don't use 90 psi for spraying, I think it is 40 psi or a little higher. You will probably be marginal have have to wait for catch up but if you tank is big enough and the dresser small enough you could be fine.

If you haven't bought the spray gun yet, look at the HVLP guns. They seem to be all the rage now. HVLP stands for High Volume, Low Pressure. That should work better for you.
08-20-2018 02:14 PM
Air paint spraying setup

I need to repaint a wood dresser and I am wondering if I can spray it with my compressor setup. I have a 3 gal oil lube craftsman compressor. It is rated at 2.4 scfm at 90 psi and 3.7 scfm at 40 psi. Is there any spray gun that will do a decent job with this compressor? It's not a big job so if I have to wait some for the compressor to "catch up", that's not a huge deal.
Or should I just give up on the idea of spraying it and roll?


Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 08:39 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
Resources saved on this page: MySQL 16.67%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
Copyright 2019
© 2013 Noreast Media, LLC | Terms of Service | Contact Us | Advertise