Question for you fiberglass folks

576 Views 5 Replies 4 Participants Last post by los is 7, Jun 11, 2006

dicklaxt

Discussion Starter · Jun 11, 2006 (Edited)

How hard is it to lay a coat of glass matt on a flat surface and get a decent finish.

I am building a bird house out if 1" thick foam insulation. I would like to cover this in glass and have a relatively nice smooth surface. It is all flat work and of course 90 degree corners. Im thinking the inside just needs to be painted with resin.This house is 31" x 26" x10",single story with a gable roof. No bathroom or kithchen all bedrooms.........rotflmao

I'm a pretty handy DIY'er so if I do it ,,,send the tips ASAP

dick

Save

1 - 2 of 6 Posts

dicklaxt

Discussion Starter · #3 · Jun 11, 2006

How much do you have to radius the corners and what is high build primer?

Speaking of radiusing the corners there sure are a lot of edges on that roof and there is 4 slideouts with, for lack of a better word, drawer fronts. I always get into these messes it seems.

dick

Save

1 - 2 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month