2 Cool Fishing Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
473 Posts
Discussion Starter · #1 ·
I bought a Ruger Red Label used a while back. It came with 5 choke tubes, but I dont know of a way to identify the different chokes (mod, full, etc...). Is there some sort of marking or way to figure out which is which????
 

·
Aspiring professional pot-stirrer.
Joined
·
20,198 Posts
Should be either marking on the side or notches on the ends: number or notches corresponds to restriction... beyond that, you could just get an inside caliper, measure the chokes and work from there.. Or just pattern them and go with the results as opposed to what Ruger says or doesn't say they are. Of course, you're probably better off just going down to Briley and getting a new set..
 

·
Cajun 2 da Bone
Joined
·
4,083 Posts
If the tubes have notches on the end of them, it should go like this.
5 notches = skeet
4 notches = IC
3 notches = MOD
2 notches = IMOD
1 notch = full
 
1 - 3 of 3 Posts
Top