2 Cool Fishing Forum banner

1 - 6 of 6 Posts

·
JP
Joined
·
548 Posts
Discussion Starter #1
check out this i made in in about 1hr pretty easy and only cost me 35 bucks not bad comparing that to the ones online for like 200 bucks all i need now is a faster motor.....that rod is very old so i cut the handle off and started workin on it






comments???
 

·
Right wing nut job, Bitter clinger to 2C
Joined
·
14,926 Posts
that will work

jake that will work just fine. BUT i think your mom will have a problem with it on her kitchen counter. you are on the right track tho.
 

·
JP
Joined
·
548 Posts
Discussion Starter #3
haha my dad told me to take it there so she wont mind cuz she was rite there :p
 

·
Registered
Joined
·
1,887 Posts
Jake,
A couple of ideas for you. Go to a hobby craft store and buy some felt lined stick-on material and line the V's on the rod holders. This will keep you from scratching the blank while turning. You can also turn your spool holder into a two spool holder by removing the bolt and using a piece of threaded rod in its place.
 

·
Registered
Joined
·
1,575 Posts
Congrats Jake...you got some great teachers here...learn all you can...
 

·
JP
Joined
·
548 Posts
Discussion Starter #6
yea im trying to absorb it all in i just brought a custom rod kit online at cabelas to start
 
1 - 6 of 6 Posts
Top