2 Cool Fishing Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
492 Posts
Discussion Starter · #1 ·
I have a small, one off job to make six parts. Two of one, four of other. Mainly 1/2" thick aluminum plate with some 1"x1" square stock tapped and bolted on.

Anyone you can recommend in Northwest Houston ? Please PM contact information or email to [email protected]

Thanks,

John
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top