2 Cool Fishing Forum banner
1 - 5 of 5 Posts

· Fish Beater
10 Posts
Discussion Starter · #1 ·
I have a 2001 model Yamaha 1200GPR. When take off the motor over revs then it catches.
1. Do I need to change the impeller cause its worned?
2. Does the impeller have a pin thats sheared?

Any solution would help.


· Registered
839 Posts
There are a number of things that can cause the problem you are experiencing. A worn impeller is likely, so is a worn wear ring, the part the impeller fits inside of. You can also be sucking air from an improperly sealed shoe (pump housing) and/or bad seal on impeller drive shaft.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.