2 Cool Fishing Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
173 Posts
Discussion Starter · #1 ·
Got a question that may have been discussed before. I have the Accu Lube system on my travel trailer. This weekend I pulled the black rubber cover and added grease via the zerk in the center. One wheel would not accept any grease. I thought bad zerk. I pulled the zerk and attached it the grease gun and it worked fine. Put it back on the spindle and again I cannot get grease in there. This is the type system where grease goes in thru the center in back towards the front.

Anyone have any idea or experienced this before. Wanted to see if I could get some feedback since my family and I are headed to the hill country this weekend with it. I was pulling the zerk again tonight and inserting a coat hanger to see if something is blocking it.
 

·
POC chunker
Joined
·
9,209 Posts
Pull the zerk and see if you can shove a piece of coathanger or similar wire in there. The grease may have dried up and is cloggoing the passage drilled through the spindle.
 
1 - 2 of 2 Posts
Top